Photography & Motorsports






The TEC3-R is what I use in the RX-8 to make the power to run low 7 second ET's


One controller for all applications - New configurable Injector Outputs allow either one or two high performance low resistance injectors to be used on each of the 8 injector drivers. (That's a total of 16 injectors) The new starting circuitry from the XDI has also been incorporated.

This single unit controls everything without the need for any additional hardware such as ignition amplifiers, chips for 2-step settings, separate 2-step modules.

Here is what I have connected to the TEC3-R:

bulletWiring Harness
bulletTypical sensors (MAP, CLT, MAT, TPS, Wide Band)
bullet4-Single post ignition coils
bulletCrank Sensor.
Send mail to with questions or comments about this web site.
Copyright 2001- 2018 Team Ken Scheepers
Turbo II Performance, Inc.    All rights reserved.